Filter
Top Products
Carlng For Your Dryer
Contlnued
lgnlter
Funnel
Gas dryer wlthout lower front accem
panel (full-fmnl pfinel removed)
-8 dryer8
wlthout
IOWW front
8cce88
panel
tl your dryer is gas and does not
have
a tower front access panel:
1. Unplug the power supply cord or
turn off the electrical power.
2. Remove lint screen.
3. Remove two screws from lint
screen area.
4. Open top by pulling forward and up
at each front comer (top is hinged
at rear).
5. Remove two internal screws from
front panel flanges (near top front
comers). Slightly lift panel off lower
clips and pull forward to disengage
from drum. Hold drum in place
..
when pulling panel forward to
prevent drum from dropping down.
6. Remove door switch wires, if
necessary. Note the wire/terminal
positions to assure proper
reassembly.
7. Remove lint from boxed-in area
with soft brush or vacuum cleaner.
Avoid damaging wires, thermostats,
funnel or igniter.
6. Reassemble in reverse order. Be
sure drum and drum seals are
positiined properly when
reassembling. Top and front panels
must be securely in place before
operating dryer.
9. Reconnect power and relevel dryer,
if necessary.
12