Carlng For Your Dryer
Continued
Lint removal
Lint can gather inside the dryer and be
a fuel for fire. ft is recommended the
lint ba removed every 2 to 3 years, or
more often, depending on dryer
usage. Cleaning shoukl be done by a
qualified person. lf you have any
questions, please call our Consumer
Assktance Center at I-800-2!53-1301.
Elodrk dryer with baclt panel removed
bnb
I II
Fu:nd
12
Gas dryer wlth lower honl
acces8 panel mfnoved
Electrical Bhock and
Personal injury Hazard
l Unplug the power suppty cord
or turn off the electrlcol power
before removlng dryer panels.
l Make sure the dryer Is cool.
l Dryer parts can have sharp
edgea Use care when han-
dllng.
l When mplaclng front panel
after lint removal, the wire clips
holding the door switch wires
must be anchored to top of
front and side panels. Wires
Ml&T NOT touch rotating
dNITI. (See page 12, step 7.)
Failure to do so could result ln
elect&al shock or personal
WV.
If your dryer Is elect&z, or ls gas
and has a lower front access panel:
1. Unplug the power supply oord or
turn off the elactrical power.
2.
Remove bade panel (elsctric) or
bwer front accsss panel (gas). See
Installation Instructions.
3. Remove lint from shaded area in
illustration with a soft brush or
vacuum deanar. Avoid damaging
wires, thermostats (elsctric). funnel
(gas) or igniter (gas).
4. Replace panel; reconnect and
level dryer again, if necessary.
NOTE: See page 13 if your dryer is
gas and has a full front panel.