Filter
Top Products
5
Recessed or closet installation - Dryer only
Recessed or closet installation - Stacked
Mobile Home - Additional Location Requirements
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 245, HUD Part 280) or Standard CAN/CSA-Z240
MH.
Mobile home installations require:
Metal exhaust system hardware which is available for
purchase from your dealer.
Special provisions must be made in mobile homes to
introduce outside air into the dryer. The opening (such as a
nearby window) should be at least twice as large as the dryer
exhaust opening.
Electrical Requir ements
A 120-volt, 60-Hz., AC-only, 15- or 20-amp fused electrical
supply is required.
A time-delay fuse or circuit breaker is recommended. Be sure
fuse or circuit breaker matches the rating of your line.
Use a separate circuit serving only your dryer.
Do not use an extension cord.
A. Side view - closet or conned area
B. Recessed area
A. Recessed area
B. Side view - closet or conned area
C. Closet door with vents
BA
3"
(76 mm)
14"
(356 mm)
18"(457 mm)
0"
(0 mm)
0"
(0 mm)
DRYER
WASHER
(76 mm)
3"
(305 mm)
12"
(305 mm)
12"
0"
(0 mm)
0"
(0 mm)
BA
C
1"
(25 mm)
3"
(76 mm)
48 in.
2
(309.7 cm )
2
24 in.
2
(154.8 cm )
2
3"
(76 mm)
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
re, or electrical shock.
WARNING
GROUNDING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
For a grounded, cord-connected dryer:
This dryer must be grounded. In the event of malfunction or
breakdown, grounding will reduce the risk of electric shock
by providing a path of least resistance for electric current.
This dryer is equipped with a cord having an equipment-
grounding conductor and a grounding plug. The plug must
be plugged into an appropriate outlet that is properly
installed and grounded in accordance with all local codes
and ordinances.
WARNING: Improper connection of the equipment-
grounding conductor can result in a risk of electric shock.
Check with a qualied electrician or service representative
or personnel if you are in doubt as to whether the dryer is
properly grounded. Do not modify the plug provided with the
dryer: if it will not t the outlet, have a proper outlet installed
by a qualied electrician.
Closet installation with WFC7500VW - Stacked
A. Recessed area
B. Side view - closet or conned area
C. Closet door with vents
DRYER
WASHER
(51 mm)
2"
(25 mm)
1"
(0 mm)
0"
0"
(0 mm)
0"
(0 mm)
BA
C
1"
(25 mm)
3"
(76 mm)
48 in.
2
(309.7 cm )
2
24 in.
2
(154.8 cm )
2
3"
(76 mm)
SHELF