Filter
Top Products
16
3. Clean the filter with a soft brush under running water until all
residue is removed.
4. Replace the filter and turn it clockwise until it is securely
locked in place. Give the cap a gentle tug to confirm that the
filter is secure.
5. Close the filter door.
Cleaning the control panel
To clean the control panel, use only a warm, damp cloth.
■ Do not spray water or cleaning solvents on the control panel.
■ Do not use abrasive cleaners or scouring pads on the outer
surfaces because they will scratch the finish and could
remove the writing on the control panel.
■ Some paper towels may also scratch the finish.
Water Inlet Hoses
Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear or leaks are found.
When replacing your inlet hoses, record the date of replacement.
Vacation, Storage, and Moving Care
Install and store your washer where it will not freeze. Because
some water may stay in the hoses, freezing can damage your
washer. If storing or moving your washer during freezing weather,
winterize it.
Non-use or vacation care:
Operate your washer only when you are at home. If you will be on
vacation or not using your washer for an extended period of time,
you should:
■ Unplug washer or disconnect power.
■ Turn off the water supply to the washer. This helps avoid
accidental flooding (due to a water pressure surge) while you
are away.
■ Slightly open door to provide ventilation.
To winterize washer:
1. Unplug washer or disconnect power.
2. Shut off both water faucets.
3. Disconnect water inlet hoses from faucets.
4. Place a pan or towel under the filter door, as a small amount
of water could spill. Open the filter door and remove the lint
filter to drain. See “Cleaning the lint filter” in the “Cleaning
Your Washer” section.
5. Reinstall the lint filter and close the filter door.
To use washer again:
1. Flush water pipes. Reconnect water inlet hoses to faucets.
Turn on both water faucets.
2. Plug in washer or reconnect power.
3. Run the washer through the Regular/Normal cycle with
¹⁄₄ the normal recommended amount of HE detergent to clean
out antifreeze.
To transport the washer:
1. Unplug washer or disconnect power.
2. Remove drain hose from the standpipe or laundry tub. Attach
the drain hose to the rear panel clips.
3. Shut off both water faucets.
4. Disconnect the water inlet hoses from faucets and rear of
washer. Drain the hoses and place them inside the washer
drum.
5. Place a pan or towel under the filter door, as a small amount
of water could spill. Open the filter door and remove the lint
filter to drain. See “Cleaning the lint filter” in the “Cleaning
Your Washer” section.
6. Reinstall the lint filter and close the filter door.
IMPORTANT: Call your local service center for assistance.
Transport bolts should be installed prior to moving. The washer
must be transported in the upright position to avoid suspension
and structural damage.
Reinstalling the washer:
1. Follow the “Installation Instructions” to locate, level and
connect the washer.
2. Run the washer through the Regular/Normal cycle with ¹⁄₄ the
normal recommended amount of HE detergent to clean the
washer and remove the antifreeze, if used.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING