Filter
Top Products
l
To stop the washer at any time, push
in the Cycle Control Knob. To restart
the washer, pull out the Cycle Control
Knob.
NOTE: Use warm water with the KNITS
GENTLE Cycle.
For heavily soiled permanent press
or knit clothes, pre-wash or presoak
before washing in warm water.
3. Select wash time and
restart the washer
l
Stop on the number in the wash cycle
you want. The numbers are minutes of
wash time. The drawing shows 10
minutes of agitation in the REGULAR
NORMAL Cycle.
l
Restart the washer by pulling out the
Cycle Control Knob.
What happens in each cycle
Each cycle has different agitation and
spin speeds designed for different kinds
of fabrics.
Numbers on the dial in each cycle are
the minutes of wash agitation time.
When the Cycle Control Knob is set
to a number and pulled out, the washer
fills before agitation and timing starts.
After agitation starts, the knob turns
clockwise until it points to OFF and the
cycle ends.
The washer will pause briefly
throughout each cycle. These pauses
are normal. They allow for the reversing
of the motor and normal washer
operation.
NOTE: You may hear the sound of
water spraying during the spin parts of
some cycles. In all cycles, water is
sprayed on the spinning load to help
with the rinsing.
Gentle Wash System
For better fabric care in the REGULAR
Cycles, the agitation speed is reduced
during the last few minutes of wash
agitation time.
5