Filter
Top Products
Operating instructions
Starting Your Washer
yI$ Be sure to measure and add detergent, then Place
a sorted load in the washer before starting it.
1
. Select a LOAD SIZE
l
Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob anywhere on or be-
tween EX SMALL [a few small items)
and EX LARGE (a full load).
l
To change the water level after the
washer has started to fill, turn the knob
to RESET, then the desired water level.
I
NOTE: Use the EX LARGE water
level for best permanent press
results.
2
Select
.
WATER TEMPERATURES
l
Select wash and rinse water tem-
peratures by pushing a button.
l
This drawing shows a warm wash
(top temperature) and cold rinse
(bottom temperature) selection.
Recommended wash temperatures
can be found in your “Laundry Guide.”
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
CAUTION:
DO NOT
OVERLOAD WASHER.
EX LARGE (21.7 gaU82.1 L)’
MEDIUM (16.8 galJ63.6 L)’
EX SMALL (11.9 gal./450 L)*
tearing of load items.
*Approximate
fill with load.