Filter
Top Products
Other operating instructions
For a rinse and spin
For a drain and spin
You may neec: an extra rinse and
spin for heavily solled loads which
need more detergent. (Extra de-
tergent can requtre an extra rinse.]
l
Push Control Knob In
. Turn clockwlse to any ‘on the dial.
See above drawing
l
Pull Control knob out
l
The washer WIII fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water.
= Push Control Knob in.
0 Turn clockwlse to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
For agitation and spin speeds in each cycle,see pages 6-9.
For a soak
l
Use recommended amount of
For best results. use warm water for
detergent or pre-soak product.
soaking stained laundry Hot water
l
Push Control Knob in.
can set stains.
l
Turn clockwise to point at a number
in the SOAK Cycle?
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“laundry Guide!’
‘To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint ftiter
Water runs through the lint filter
whenever the washer agitates
Check it ofien to make sure it’s clean
and is filtering at its best.
To remove it for cleaning. press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter
IO