Filter
Top Products
Soak or pre-wash cycle
For best results, use warm water for
soaking or pre-washing stained laundry.
Hot water can set stains.
1. Use recommended amount of pre-
soak product or detergent.
2. Push Cycle Control Knob in.
3. Turn clockwise to point to a number
in the SOAK Cycle. Use the 4 minute
mark for the PRE-WASH Cycle.
4. Pull Cycle Control Knob out. The
washer will start.
5. When the cycle is over, add deter-
gent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a wash cycle.
NOTE: See the Laundry Guide for
additional soaking information.
Liquid bleach dispenser
Always measure bleach. Do not guess.
Never use more than 1 cup (250 mL)
for a full load. Use less with lower water
level settings. Follow directions on
bottle for safe use. Use a cup with a
pouring spout to avoid spilling.
Load the washer first:
Pour measured bleach carefully into
dispenser. Do not let bleach splash,
drip or run down into washer basket.
Undiluted bleach will damage any
fabric it touches.
Start the washer. Bleach will be
diluted automatically during the wash
part of the cycle.