Operating instructions
Starting Your Washer
Be sure to measure and add detergent, then place
a sorted load in the washer before starting it.
I
. Select
a
LOAD SIZE
2
Select
.
WATER TEMPERATURES
l
Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob anywhere on or be-
tween HAND WASHABLE (a few small
items) and EX LARGE (a full load].
l
To change the water level after the
washer has started to fill, turn the knob
to RESET, then the desired water level.
NOTE: Use the EX LARGE water
level for best permanent press
results.
l
Select wash and rinse water tem-
peratures by pushing a button.
l
This drawing shows a warm wash
(top temperature) and cold rinse
(bottom temperature) selection.
Recommended wash temperatures
can be found in your “Laundry Guide:’
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
tearing of load items.
0
CAUTION:
DO NOT
OVERLOAD WASHER.
*Approximate
fill with load.
EX LARGE (21.7 galsI82.1 L)’
MEDIUM (16.4 gals./62.1 L)’
EX SMALL (II.9 gals.145.0 L)’