Filter
Top Products
Liquid bleach dispenser
Always measure bleach. Do not
guess Never use more than 1 cup
(250 ml) for a full load. Use less with
lower water level settings. Follow
directions on bottle for safe use. Use
a cup with a pouring spout to avoid
spilling.
1. Load the washer ftrsf
2. Pour measured bleach carefully
tnfo dispenser DO NOT let bleach
I
j
splash, drip or run down into the
washer basket Undiluted bleach
will damage any fabric it touches.
c
’
3. Start the washer. Bleach will be
diluted automatically during the
wash part of the cycle.
For more information on bleaching, see”Laundry Guide” page 11.
I
nser
4. Dilute fabric softener with hot
water. Add enough hot water to fill
the dispenser up to the opening.
5. Stat-f the washer. Diluted liquid fab-
ric softener will be added to the
load during the deep rinse poftfon
of the cycle. I
NOTE: Do not stop the washer
durlng this time. If you do, the
I
softener will mix with the remaining
soapy wash water. This will cause
1. Add detergent and load to the
stains. Do not
put
detergent In the
basket.
liquid fabric softener dlspenser.
2. Add liquid fabric softener to
6. If dispenser needs cleaning, flush
the dispenser using the amount
with hot water. NOTE: Do not wash
recommended on the bottle.
clothes wlth dlspenser removed.
3. Avoid dripping or spilling any fab-
ric softener
on the load.
Cleaning the lint filter
.
LpqI’f= t
/I IL!!&1 \
1
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of llnt build-up.
To clean:
l
Litt off the agitator barrel.
I
l
Wash or wipe the filter clean in the
t”;
DnKmx 7
bottom of the agitator barrel. The
c
/ A-
filter is not removable.
l
Replace the agitator barrel and
snap into place.
.