Filter
Top Products
Operating instructions
Starting Your Washer
a
/-
Be sure to measure and add detergent, then place
-1 a sorted load in the
washer before
StarWW it.
1 .
Select a LOAD SIZE
2
Select
.
WATER TEMPERATURES
l
Turn the knob to point at a setting
that describes the size of load you
want to wash.
l
Set the knob anywhere on or be-
tween EX SMALL (a few small items]
and EX LARGE (a full load).
l
To change the water level after the
washer has started to fill, turn the knob
to RESET, then the desired water level.
NOTE: Use the EX LARGE water
level for best permanent press
results.
4
l
Select wash and rinse water tem-
peratures by pushing a button.
l
This drawing shows a warm wash
(top temperature) and cold rinse
(bottom temperature] selection.
Recommended wash temperatures
can be found in vour “Laundrv Guide:’
LOAD SIZES AND WATER LEVELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or too
little water can cause wear or
CAUTION:
DO NOT
OVERLOAD WASHER.
tearing of load items.
‘Approximate
fill with load.
EX LARGE (21.7 galsJ82.1 L)’
MEDIUM (16.4 gais.162.1 L)’
EX SMALL (11.9 gal./450 L)’