Filter
Top Products
Other operating instructions
I
For a rinse and spin
For a drain and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.]
l
Push Control Knob in.
l
Turn clockwise to any .on the dial
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water.
l
Push Control Knob in.
l
Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6 - 9.
For a soak
pull s1ar1
‘To start soak with agitation, the Cycle
Control Knob must point to a number
in the SOAK Cycle.
For best results, use warm water
for soaking stained laundry. Hot
water can set stains.
l
Use recommended amount of
detergent or pre-soak product.
l
Push Control Knob in.
l
Turn clockwise to point at a number
in the SOAK Cycle:
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“Laundry Guide!’
l
Set the washer and start the next
selected wash cycle.
MAGIC CLEAN@ lint filter
The lint filter in your washer cleans itself. Collected
lint is drained away with the wash and rinse water.
If your washer drains into a tub, remove any lint
,0 collected in the drain or strainer.