Filter
Top Products
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. [Extra de-
tergent can require an extra rinse.)
l
Push Control Knob in.
l
Turn clockwise to any ‘on the dial.
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For a drain and spin
Your washer can be set to drain
and spin out water.
l
Push Control Knob in.
. Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
For agitation and spin speeds in each cycle,see pages 6-9.
For a soak
l
Use recommended amount of
For best results, use
warm
water for
soaking stained laundry.
Hot water
detergent or presoak product.
l
Push Control Knob in.
can set stains.
l
Turn clockwise to point at a
number
l
in the SOAK Cycle.’
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
lnformation on page 7 of your
“Laundry Guide:’
‘To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint falter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure its clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.
10