Filter
Top Products
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse )
9 Push Control Knob in.
l
Turn clockwise to anyeon the dial.
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected level;
agitate 2 minutes; drain and spin.
For a soak
For best results, use warm water
for soaking stained laundry. Hot
water can set stains.
l
Use recommended amount of
detergent or pre-soa k product.
For a drain and spin
Your washer can be set to drain
and spin out water
l
Push Control Knob in
l
Turn clockwise to the bar lust before
OFF In any cycle See above
drawing.
. Pull Control Knob out.
l
The washer will drain and spin.
l
Push Control Knob In.
l
Turn clockwise to point of a number
in the SOAK Cycle...use the 6-minutes
mark for a pre-wash.’
l
Pull Control Knob out to start washer
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“laundry Guide!’
l
Set the washer and start the next
selected wash cycle.
*To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of lint build-up.
c
To clean:
l
Lift off the agitator barrel.
l
Wash or wiDe the filter clean in the
bottom of <he agitator barrel. The
filter is not removable.
l
Replace the agitator barrel and
10
snap into place.