Filter
Top Products
Other operating instructions
For a rinse and spin
For a drain and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.)
Your washer can be set to drain
and spin out water.
l
Push Control Knob in.
l
Turn clockwise to the bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out.
l
The washer will drain and spin.
l
Turn clockwise to paint at a number
in the SOAK Cycle...use the 6-minute
mark for a pre-wash.*
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a Wash
Cycle.
Important: See additional care
information on page 7 of your
“laundry Guide!’
l
Set the washer and start the next
selected wash cycle.
l
Push Control Knob in.
l
Turn clockwise to any. on the dial.
See above drawing.
l
Pull Conirol Knob out.
l
The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For a soak
For best results, use warm water
for soaking stained laundry. Hot
water can set stalns.
l
Use recommended amount of
detergent or pre-soak product.
l
Push Control Knob in.
‘To start soak with agitation, the Cycle Control Knob
must point to a num
Cleaning the lint
filter
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of lint bull+up.
To clean:
l
Lift off the agitator barrel.
l
Wash or wipe the filter clean in the
bottom of the agitator barrel. The
filter Is not removable.
l
Replace the agitator barrel and
,O snap into place.