Filter
Top Products
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra detergent
can require an extra rinse.)
1.
Push Control Knob in.
2. Turn clockwise to any
l
on the dial.
See above drawing.
3. Pull Control Knob out. The washer
will fill to selected level; agitate 2
minutes; drain and spin.
For a drain and spin
Your washer can be set to drain and
spin out water.
1.
Push Control Knob in.
2. Turn clockwise to the bar just before
the OFF area in any cycle. See
above drawing.
3. Pull Control Knob out. The washer
will drain and spin.
For agitation and spin speeds in each cycle, see pages 6-9.
For a soak or pre-wash
For best results, use
warm
water
for soaking or pre-washing stained
laundry.
Hot water can set stains.
1.
Use recommended amount of
detergent or pre-soak product.
2. Push Control Knob in.
3. Turn clockwise to point to the
number
in the SOAK Cycle.
4. Pull Control Knob out. The
washer will start.
5. When the cycle is over, add
detergent for the next selected
wash cycle. The
SOAK Cycle
should always be followed by
a Wash Cycle.
Important: See addltlonal care
Informatlon on page 7 of your
“Laundry Guide!’
‘To start soak with agitation, the Control Knob
must point to a number in the SOAK Cycle.
10