Filter
Top Products
Other operating instructions
For a rinse and spin
For a drain and spin
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent. (Extra de-
tergent can require an extra rinse.)
l
Push Control Knob In
l
Turn clockwlse to any .on the dial
See above drawing.
l
Pull Control Knob out.
l
The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water.
l
Push Control Knob in.
. Turn clockwise to Ihe bar just before
OFF in any cycle. See above
drawing.
l
Pull Control Knob out
. The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6and 7.
For a soak
l
Push Control Knob in.
l
Turn clockwise to point at a number
in the SOAK Cycle...use the &minutes
mark for a pre-wash?
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
cycle. The SOAK Cycle should
For best results, use warm water
always be followed by a Wash
for soaking or pre-washing stained
Cycle.
laundry. Hot water can set stains.
Important: See additional care
l
Use recommended amount of
information on page 7 of your
detergent or pre-soak product. “Laundry Guide!’
‘To start soak or pre-wash with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Clean filter after every load for best
filtering results. Note: The load type
will vary the amount of llnt build-up.
To clean:
l
Lift off the agitator barrel.
l
Wash or wipe the filter clean in the
bottom of the agitator barrel. The
ftlter Is not removable.
l
Replace the agitator barrel and
snap into place.
0