Filter
Top Products
Exhaust requirements
8
INSTALLATION INSTRUCTIONS
Your dryer must be properly vented to
achieve maximum drying efficiency.
WARNING: To reduce the risk of fire,
this dryer MUST BE EXHAUSTED
OUTDOORS.
• Do not exhaust dryer into a chimney, a
wall, a ceiling, or a concealed space of a
building.
• The diameter of the heavy metal vent must
be 4 in (10.16 cm).
• Do not use an exhaust hood with a
magnetic latch.
If using an existing exhaust system, remove
accumulated lint.
1. Disconnect vent from the dryer and clean
one section at a time until you reach the
exhaust hood.
2. Use the hose attachment on your vacuum,
or a pole with a feather duster or rag
attached, to clean out lint.
3. Be sure the flapper on the outside end of
vent moves freely. Make sure exhaust
hood is not plugged with lint.
Clean exhaust vent periodically, depending
on use, but at least every 2 years, or when
installing your dryer in a new location.
wWARNING
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions
can result in death or fire.
Casters
To install the casters, first lay dryer on its
side. Use the carton to prevent damage to
the dryer. Screw casters into dryer base at
four corners and tighten securely. Set dryer
upright. In doing so be careful that dryer
does not roll away from you.
Leveling feet (Part No. 51594200) for use in
permanent installations may be purchased.
See the “Assistance or Service” section.
Threaded hole
Caster
Caster installation only
3977624v18c27 2/11/2000 2:06 PM Page 8