Filter
Top Products
If your dryer is gas and has a
full front panel, remove front
panel as follows:
1. Unplug the power supply cord or turn off the
electriil power.
2. Open lint screen lid. Remove two xrews from
lint screen area.
3. Open top by pulling forward and up at each
front cOrner (see view A). Rest raised top
against wall behind dryer (top is hinged
at rear).
4. Remove two internal screws from front panel
flanoes (near toci front comers). Lii front panel
5.
6.
7.
8.
9.
sligkly, king oh bwer dips (see view B):
Slowly pull front panel forward, disengaging
panel from drum. (Drum will drop slightly.)
Move front panel aside and rest edge against
side of dryer. Avoid disconnecting wire clips
(see view C) or damaging wires.
Remove lint from area shown in pas dryer
illustration on page 11 with soft brush or
vacuum cleaner. Avoid damaging wires,
funnel or igniter.
Reassemble in reverse order. Before closing
the top, chedc the following:
- Drum seal must be flared out (see view D)
and properly positioned against panel at
bade of drum. Rotate drum countercbck-
wise one full turn to check drum seal.
- Bet! should be centered and tight on
dryer drum.
- Wire clips which hold the door switch wires
must be anchored in sbt in top of front
panel (see view C) and along top edge of
side panel. Door wires must not touch drum
when dryer is operating. Sm Warning,
page 11.
Replace top panel and lint screen screws. Top
and front panels must be securely in place
before operating dryer.
Reconnect power and level dryer again
(I necessary).
Removaaoraws
befom opatlng top
Drum seal
Side wand
(aw vlei B)
4
8
VkWB
Wire dlp-
holds door
NOTE: Call Consumer Assistance at
l-800-447-8737 for assistance or more
information.
12