Special offers from our partners!
Is your Washer broken? Check out PartSimple for your replacement Parts!
Open as PDF
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher (1
If the indicator flashes repeatedly, see page 6 -
chapter ”What to do if ...”.
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program. When the door is opened during a
washing cycle, the cycle is temporarily paused: the
Start indicator blinks.
To resume the cycle push the Start button and
close the door within 3 seconds.
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions
(without additional options) and may vary depending on conditions. Differences of up to 20 minutes are possible
with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for
detailed information on the EN/Standard loading comparison test and other tests, contact the following address:
Table of programs
Programs Loading instructions
1 Pre-Wash cold
Crockery to be washed later. — 5.0 0.02 10
2 Quickwash 40°C
Lightly soiled crockery, with no
X 13.0 0.70 30
Normally soiled crockery.
X 15.0 1.05 165
4 Intensive 70°C
Recommended program for
heavily soiled crockery, especially
suitable for pans and saucepans.
X 15.0 1.50 140
5 Half Load 50°C
Ideal for washing a half load of
lightly or normally soiled crockery.
X 13.0 1.00 130
5019 396 03515ADG 6500
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ
THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING
ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Quick reference guide