Whirlpool ADG 6500 Washer User Manual


 
GB
-5-
Switching off the appliance. Everything OK...
Wash cycle
Select program
6
7
8
Maintenance and care
Maintenance and care
Overview of programs
The max. possible number of programs is illustrated in the chapter “Chart”. The corresponding programs for your appliance can be found on the panel (page 1).
Choose program according to the attached table of programs (page 1).
Duration of the program depends on the external conditions in the apartment, temperature and pressure etc.
Rectifying minor faults yourself...
10
9
Filters
Check and
clean if
necessary
Unscrew
microfilter (1),
remove it (2)
and remove
fine sieve (3)...
Rinse under
running water...
Screw on microfilter NOTE MARK!
Unscrew
and remove
lower arm...
Spray arms
Remove
blockages/
deposits.
Insert
Clean spray
nozzles under
running water
(use toothpicks
if necessary)...
Insert and screw on upper and lower arms tightly.
Unscrew
and remove
upper arm...
After the program is completed appliance turns into
Standby
mode automatically. All indicator lamps switch off.
Exercise caution when opening the door: beware of hot steam.
Unload the appliance starting from the lower rack in order to avoid any residual drips of water falling onto crockery below.
The dishwasher door must be closed and the water tap open.
To pause the program (e.g. if you want to insert an item):
- Open the door with caution (the program pauses) and insert
the item/s,
(beware of HOT steam!)
.
-Press the
START
button and close the door within 3 seconds
(the program resumes the cycle from where it was
interrupted).
To Cancel the program on running:
- Open the door, press the
CANCEL/
Off
button and close the door.
- (Water drains for up to 1 minute then
the appliance switches off).
To change the program in progress:
- Open the door, press the
CANCEL/Off
button to cancel the
running program and close the door.
- (Water drains for up to 1 minute then the appliance switches off).
- Open the door and press any button except
CANCEL/Off
button to
switch on the appliance.
- Select a new program.
- Press the
START
button and close the door within 3 seconds