Filter
Top Products
Use new hoses and washers that
came with your Whirlpool washer.
Replace inlet hoses after 5 years of
use to reduce the risk of hose failure.
Inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are
found. When replacing your inlet
hoses, mark the date of replacement
on the label with a permanent
marker.
2. Insert a flat washer into each
end of the inlet hoses. Check that
washers are firmly seated in
couplings.
coupling
3. Attach hose to bottom inlet
valve opening first. Then second hose
to top inlet. Tighten couplings by
hand; then use pliers to make an
additional two-thirds turn.
Slide washer onto cardboard or
hardboard before moving across
floor.
PAGE 4
Inlets are plastic.
Do Not strip or
crossthread.
hot water
inlet valve
cold
water
inlet
valve
washer
4. Move washer close to final
position. Put “hook” end of drain hose
into standpipe. Estimate length of
drain hose needed when washer is in
final position. Hose must be cut
exactly to length so “hook” end is
held tightly over edge of standpipe. If
drain hose is too long, cut straight end
of hose. (Do Not cut “hook” shaped
end of drain hose.)
DO NOT FORCE EXCESS LENGTH OF
DRAIN HOSE DOWN THE STANDPIPE.
THIS COULD CAUSE SIPHONING. See
Step 6.
5. Place hose clamp over washer
drain connector. Push drain hose onto
washer connector. Use pliers to open
clamp and slide clamp over drain
hose. Check for good fit.
6. Measure and mark a point
approximately 16 inches (40.6 cm)
from the plug end of the shipping
strap. Cut this shipping strap at this
point.
Check that hose is not
twisted or kinked and is
securely in place.
Put “hook” end of drain
hose into standpipe.
Tightly wrap the shipping
strap around the
standpipe. Push plug into
the nearest hole in the shipping strap.
16" (40.6 cm)
Now start...
Pull firmly to remove the end of
shipping strap from the back of the
washer. The shipping strap plug must
be completely removed from the
washer for the self-leveling legs to
be released.
Save the shipping strap for use in
Step 6.
Excessive Weight Hazard
Use two or more people to move
and install washer.
Failure to do so can result in back
or other injury.
WARNING
shipping
tape
Pull the strap completely
out of the washer.
1. Remove tape that covers
shipping strap. Pull to completely
remove the shipping strap with 2
cotterpins from the inside of the washer.