Filter
Top Products
13
■ Is the dryer located in a room with temperature below
7ºCF (45ºF)?
Proper operation of dryer cycles requires temperatures above
7ºCF (45ºF).
■ Is the dryer located in a closet?
Closet doors must have ventilation openings at the top and
bottom of the door. The rear of the dryer requires 12.7 cm (5")
of airspace for most installations, and 2.5 cm (1") is
recommended for the sides and front of the dryer. See the
Installation Instructions.
■ Has an air dry cycle been selected?
Select the right cycle for the types of garments being dried.
■ Is the load too large and heavy to dry quickly?
Separate the load to tumble freely.
Lint on load
■ Is the lint screen clogged?
Lint screen should be cleaned before each load.
Stains on load or drum
■ Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can
stain your garments.
Drum stains are caused by dyes in clothing (usually blue
jeans). This will not transfer to other clothing.
Loads are wrinkled
■ Was the load removed from dryer at the end of the cycle?
■ Was the dryer overloaded?
Dry smaller loads that can tumble freely.
Odors
■ Have you recently been painting, staining or varnishing in
the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
■ Is the electric dryer being used for the first time?
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
ASSISTANCE OR SERVICE
Before calling for assistance or service, please check the
“Troubleshooting” section. It may save you the cost of a service
call. If you still need help, contact the dealer from whom you
purchased the dryer, or a Whirlpool designated service company.
When calling, please know the purchase date and the complete
model and serial number of your appliance. This information will
help us to better respond to your request.
If you need replacement parts
If you need to order replacement parts, we recommend that you
use only factory specified parts. These parts will fit right and work
right because they are made with the same precision used to
build every new WHIRLPOOL
®
appliance.
To locate replacement parts in your area
Contact the dealer from whom you purchased the dryer, or a
Whirlpool designated service company.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 46 cm (18 inches) above the floor
for a garage installation.
Failure to do so can result in death, explosion,
or fire.