Filter
Top Products
Part No. 8318424 Rev. A
Part No. 8318424 Rev. A
©2000 Whirlpool Corporation Printed in U.S.A.Benton Harbor, Michigan 49022
Installation
Instructions
IMPORTANT:
Read and save these instructions.
Installer: Leave Installation Instructions with the homeowner
Homeowner: Keep Installation Instructions for future reference.
Save Installation Instructions for local electrical inspector’s use.
230-volt, 50-Hz
Washer
for models
3RLBR8543
3RLSQ8000
3RGSC9455
3SLSQ7533
3RLSQ8533
Completing installation
Check that all parts are now installed. If there is an extra part, go
back through steps to see which step was skipped.
Turn on water faucets and check for leaks. Tighten couplings if there
is leaking. DO NOT OVERTIGHTEN; this could cause damage to
couplings.
Check that you have all of your tools. Check that the shipping
strap was removed from the back of the washer and used to
secure the drain hose.
Untape and plug power supply cord into earthed outlet.
Read the Use and Care Guide. Start the washer and allow it to
complete the regular cycle.
Congratulations!
You have successfully installed your new Whirlpool washer. To
get the most efficient use from your new washer, read your Use
and Care Guide.
Keep Installation Instructions and Use and Care Guide.
Call your dealer or local authorized service company.
When you call, you will need the washer model number and serial
number. Both numbers are on the model/serial rating plate located
under the washer lid and on the top of the washer.
Need assistance?
CHECK ELECTRICAL REQUIREMENTS. BE SURE YOU HAVE
CORRECT ELECTRICAL SUPPLY AND RECOMMENDED
EARTHING METHOD.