Filter
Top Products
For Rinsing Only
Your washer can be set to rinse
only Use the setting for an extra rinse,
or for laundry that only needs a rinse
and sprn
There IS a dot just after the num-
bers In PERMANENT PRESS, REGULAR
HEAVY and KNITS GENTLE. If you push
In on the Cycle Control Knob, turn
the pointer to one of those dots and
pull the Control Knob out, the washer
WIII fill, agitate, drain and sprn
If you want hrgh agitatron and
sprn, use the dot In REGULAR HEAVY. If
you want low agitation and spin, use
the dot in KNITS GENTLE Use the dot In
PERMANENT PRESS if you want high
agitation and a low-speed spin
For Spinning Only
There may be times when you
want to dram out all the wash water
and start over. To stop the washer at
any time, just push In on the Cycle
Control Knob
To set the washer so it drains
and spans water out of the load, push
in on the Control Knob, turn the dial to
the right (clockwise) so the pointer
IS
touching the bar just before OFF in
any cycle
The washer WIII drain, spin out
water and stop. If You want a low-
speed spin, use the bar on PERMA-
NENT PRESS or KNITS GENTLE All the
other cycle settings
have a
hrgh-soeed
Water levels and
load Sizes
The LOAD SIZE SELECTOR lets
you control the amount of water that fills
the washer. The selector can be set at
any water level between HANDWASH-
ABLE and EXTRA LARGE.
WATER LEVELS
Setting
Gallons/Liters”
HANDWASHABLE
7.8/29.5
MEDIUM 13.9/52.6
EXTRA LARGE 20.5i77.6
*Approximate fill with load.
To change the water level setting,
move the LOAD SIZE SELECTOR to
RESET. Then move it to the setting you
want. To save water and energy,
match the water level to the load
size.
For the best cleaning results, the
load should move freely in the water.
Watch for rollover. An item (like a sock]
should sink in the middle and come
up later on the outside.
Be sure to read pages 11 13 in
your laundry Guide. You will find more
information on loading and load sizes.