Whirlpool 3397627C Clothes Dryer User Manual


 
10
Change Door Swing
If not reversing door swing, skip ahead to “Level and Exhaust the
Dryer” steps.
Avoid scratching or chipping paint.
A
B
E
C
D
1. Place a large towel or soft cloth (A) on top of dryer to avoid
damaging the surface.
2. Open dryer door. Remove bottom screws from cabinet
side of hinges (B). Loosen (do not remove) top screws from
cabinet side of hinges.
3. Lift door until top screws in cabinet are in large part of hinge
slot. Pull door forward off screws. Set door (handle side up)
on top of dryer. Remove top screws from cabinet.
4. Remove screws attaching hinges to door.
5. Remove screws at top, bottom, and side of door. Holding
door over towel on dryer, grasp sides of outer door and
gently lift to separate it from inner door. Do NOT pry apart
with putty knife. Do NOT pull on door seal or plastic door
catches.
6. Turn and reattach outer door panel to inner door panel so
handle is on the side where hinges were just removed. Be
sure to keep cardboard spacer centered between doors.
7. Attach door hinge to door so large part of hinge slot is at
bottom of hinge.
8. Gently remove 4 hinge hole plugs (C) on left side of cabinet.
Insert plugs in hinge holes on right side of cabinet.
9. Insert screws in bottom holes on left side of cabinet. Tighten
screws halfway. Position door so large end of door hinge
slot is over screws. Slide door up so screws are in bottom
of slots. Tighten screws. Insert and tighten top screws in
hinges.
10. Remove door strike (D) from cabinet. Remove door strike
plug. Insert door strike in new hole and secure with screw.
Insert door strike plug in original door strike hole and secure
with screw.
11. Close door and check that door strike aligns with door catch
(E). If door does not close completely, slide door catch left or
right within slot until strike snaps into catch.