Filter
Top Products
Using rinse and spin
NOTE: An Extra Rinse option is available in
some cycles. See page 7.
When using extra detergent for heavily
soiled clothes, or washing special-care
items, you may find an extra rinse and spin
is needed.
1. To add an additional rinse, push in the
Cycle Control Knob and turn clockwise to
RINSE, as illustrated.
2. Pull out the Cycle Control Knob. The
washer fills to selected load size,
agitates, drains, and spins.
Using drain and spin
A drain and spin may help shorten drying
times for some heavy fabrics or special-care
items by removing excess water.
1. Push in the Cycle Control Knob and turn
clockwise to SPIN, as illustrated.
2. Pull out the Cycle Control Knob. The
washer drains, then spins.
Understanding normal washer sounds
Your new washer may make sounds that
During drain
your old one didn’t. Because the sounds are
unfamiliar, you may be concerned about
The rate that water is drained from your
them. Don’t be; most of them are normal.
washer depends on your installation. If water
The following describes some of the
is drained quickly from the washer, you may
sounds you may hear and what causes
hear air being pulled through the pump. This
them.
happens during the end of draining.
During washing
After drain and before spin
When you select a small load size setting for
When the cycle changes from draining to
a small wash load, your washer has a lower
spinning, you may hear gears engaging.
water level. With this lower water level, you
may hear a clicking sound from the upper
portion of the agitator.
9