Filter
Top Products
Recessed area
instructions
This washer may be installed in a
recessed area or closet.
The installation spacing is minimum
allowable.
Additional spacing should be
considered for ease of installation
and servicing.
If closet door is installed, the
minimum air openings in top and
bottom are required. Louvered
doors with air openings in top and
bottom are acceptable.
Companion appliance spacing
should be considered.
If you need
assistance...
Call your dealer or local
authorized service company.
When you call, you will need the
washer model number and serial
number. Both numbers are on the
serial/rating plate located under
the washer lid and on the top of
the washer.
Part No. 3358974
0 1993 Whirlpool Corporation
00
Closet door
Closet door
+Q= $6
d
II
cm
max.)
4’ -ir
(10.2 cm)
l
Additional clearances for wall, door
and floor moldings may be required.
Front view
(door not shown)
Side view
Front view
Minimum installation spacing
Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022
ii.6 cm)
T
+_
3’
(7.6 cm)
T-
Printed in U.S.A.