Filter
Top Products
Recessed area
instructions...
Closet door
This washer may be installed in a
recessed area or closet.
The installation spacing is in inches and is
minimum allowable. Additional spacing
should be considered for ease of
installation and servicing.
If closet door is installed, the minimum air
openings in top and bottom are required
Louvered doors with air openings in top
and bottom are acceptable.
Companion appliance spacing should
be considered.
,‘F
00
(43.kI’cm)
ii
rl
If you need
assistance...
Call your dealer or local authorized
(0 Ocm)
(0 Ocm)
1” min.
(2.5 cm min.)
48 sq. in.
(310 sq. cm)
24 sq. in.
(155 sq. cm)
service company.
Additional clearances for wall, door
and floor moldings may be required.
, . ,,
,, ,,,
,,
wnen you call, you ~111 neea tne wasner
model number and serial number. Both
numbers are on the serial/rating plate
located under the washer lid and on the
top of the washer.
Front view
(door not shown)
Front view
Side view
Minimum installation spacing
Part No. 3358968
0 1992 Whirlpool Corporation
Prepared by Whirlpool Corporation, Benton Harbor, Michigan 49022
Printed in U S.A.
3”
(7.6 cm)
3”
(7.6 cm)