Filter
Top Products
Owner options (coin
operated models)
CAUTION: Disconnect power cord.
1. For EXTRA SPIN - 2 minutes.
l
Remove meter case service door.
l
Loosen (2) screws on the timer
mounting bracket and lift the timer out.
l
Connect BK to BK2
2. For WARM RINSE and WATER SAVER:
l
Remove screws from each end of
the console bottom.
l
Pull the console bottom forward; lift
and tilt it back.
a. WARM RINSE
l
Connect Jl to J2.
b. SAVE WATER
l
Pull out tab on water-level switch.
3. If use of a larger coin vault, lock and
key is desired, conversion bar in lower
portion of coin vault area can be
removed.
4. If additional security is needed, top
and cabinet can be locked to
washer back panel by using a “screw
type” lock and key in space provided
in top panel under console. The
“screw type” lock and key are
available from usual industn/ sources,
Check list for washer
operation.
Check the following if the washer is not
operating properly:
1. Power cord is plugged in.
2. Circuit breakers are not tripped or
fuses blown.
3. Timer has been advanced to start of
a cycle.
4. Water faucets are turned on.
5. Inlet and drain hoses are not kinked.
6. Washer lid is closed.
7. Inlet valve is frozen if not protected
from the weather,
8. Suds level. Excess suds will slow the
spin and cause poor rinsing.
Operate the washer through a
complete cycle with no detergent.
Use less detergent or a controlled
suds type detergent in future loads.
load
Loading
Load
Loading
Type
Suggestion
TYpe
Suggestion
3 double sheets
4 pillowcases
3 pair pants
Mixed
8 T-shirts
Heavy
3 shirts
Load
6 pair shorts
work
1 coverall
2 shirts
clothes
4 pair jeans
2 blouses
1 overall
8 handkerchiefs
2 double or
1 king size sheet
1 tablecloth
3 blouses
Permanent
1 dress
4 slacks
Press
1 blouse
Knits
6 shirts
2 slacks
4 tops
3 shirts
4 dresses
2 pillowcases
FZZEi2Zns
,
.
Fire Hazard
NEVER wash items cleaned,
washed, soaked in or spotted with
wax, paint, gasoline, or flammable
fluids in the washer.
The fumes can create a FIRE
HAZARD or EXPLOSION. ALWAYS
hand launder and air dry fabrics
containing these materials.
Moving the washer
to a new location.. .
It is recommended that fiberglass
items not be washed in coin-
operated washers. If these
items are washed in the washer, run
the washer through a complete cycle
to rinse any residue away that might
be left in the washer.
l
Remove the front feet from the base
of the washer.
l
Place both rear leveling legs on the
upper position and tape securely.
l
Apply tape to the side and bottom of
the cabinet near the rear.
l
Open washer lid, wedge a blanket
between the tub ring and the
cabinet top restricting the tub
movement.
l
Handle washer carefully. Do Not
drop washer while using hand
truck.
PAGE 5