Filter
Top Products
Using rinse and spin
When using extra detergent for heavily soiled
clothes, or washing special-care items, you
may want an extra rinse and spin.
1.
Push the Cycle Control Knob in and turn
clockwise to one of the dots on the dial, as
illustrated.
2. Pull Cycle Control Knob out. The washer
will fill to selected level, agitate, drain, and
spin.
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills (to the
selected water level) before agitation and
timing start. The washer will begin agitating
immediately after filling; agitation can occur
with the washer lid up or down.
After agitation starts, the Cycle Control Knob
turns clockwise until it points to OFF and the
cycle ends.
The washer pauses briefly throughout
each cycle.
These pauses are normal for
washer operation.
WASH
RINSE
M
4
Fill
Wash*
‘Agitation speed is reduced in the last few minutes
of most cycles. This provides better fabric care.
Drain (or partial drain*)
No agitation
‘The Permanent Press cycle partially
drains. fills, agitates briefly, and drains
EJ
4
Spin
w
4
Fill
Rinse
Drain-No agitation
LJ
&I
Spin