Filter
Top Products
MAINTENANCE INSTRUCTIONS
7
TROUBLESHOOTING SUGGESTIONS
PROBLEM POSSIBLE CAUSE SUGGESTED REMEDY
No power to unit
Power cord unplugged Plug power cord into appropriate receptacle
Circuit breaker tripped Reset circuit breaker
Power cord or plug damaged Replace power cord assembly
Base does not heat
ON/OFF switch OFF Press switch to “ON”
Damaged wiring or heating element Repair wiring / replace element
Lamp burned out
Replace lamp
IMPORTANT: use only 40W safety-coated lamp
Damaged wiring Repair wiring
Cabinet light not lit
WIRING DIAGRAM
233 306224 Owners Manual WNA-Series Nacho Cabinet
CAUTION:
INJURY HAZARD
Disconnect appliance from
electrical power before
performing procedure.
CAUTION:
BURN HAZARD
Lamp may be hot.
Allow lamp to cool before
replacing
.
CHANGE CABINET LIGHT LAMP
1. Press warmer switch “OFF”.
Allow unit to cool before replacing
lamp.
2. Squeeze top and bottom portions
of guard until the bottom hook
clears the slot. Slide the top hook
from its slot, then remove the
guard.
3. Unthread old heat lamp from its
socket and discard.
4. Thread new heat lamp into socket.
IMPORTANT: Use only 40W safety-coated lamp
5. Reinstall guard.