Filter
Top Products
FILLING BOILER WITH WATER
1. Place Compact Fabric Steamer on a at, level surface.
2. Make sure power cord is unplugged from electrical outlet.
3. Remove Boiler Cap by unscrewing it in a counter-clockwise direction. This will expose the
Boiler’s ll hole.
CAUTION: If unit has been in use, allow Boiler to cool (5 minutes for minimum cooling)
before removing Boiler Cap and adding water.
4. Carefully ll Boiler with water from a faucet, bottle or cup. Use Boiler Level Window to gauge
water level, stopping when it reaches the MAX mark.
NOTE: MAX mark on Boiler Level Window represents the unit’s maximum usable water
capacity (7 oz. / 200 ml.). Exceeding this amount will result in water spitting from Steam
Nozzle.
NOTE: In order to minimize potential mineral build-up and prolong the life of your
Compact Fabric Steamer, distilled or de-mineralized water is recommended when lling
Boiler.
5. Replace Boiler Cap by screwing it in a clockwise direction back into Boiler’s ll hole. Do not
over-tighten Boiler Cap.
CONNECTING ACCESSORIES
1. Select either Fabric Brush or Lint Remover – only one accessory can be used at a time.
2. Insert your selected accessory into Accessory Adapter (FIGURE 1-A).
3. Slide Accessory Adapter (with inserted accessory) onto Steam Nozzle (FIGURE 1-B). Make
sure Accessory Adapter is oriented as shown, to prevent blocking steam ow.
1-A 1-B
FIGURE 1
6
Using Your
Compact Fabric Steamer