Filter
Top Products
2
Note:
The height of the dryer from top to floor is 38" with the leveling leg screwed all the way in. The customer can
unscrew the leg out an additional 7\8" for a total overall height of 38 7/8".
• Teflon tape or pipe
joint compound (gas only)
• Cutting knife
• Pipe wrench (gas only)
• Nut drivers
• Level
• Screw driver (standard)
• Duct tape
• Crescent wrench
ITEMS PROVIDED
Electric Dryer
Only
Gas Dryer
Only
Tools needed for installation
CABINET DIMENSIONS
Proper installation is the responsibility of the owner.
HOWEVER, SERVICE CALLS PERFORMED AS A RESULT OF POOR SET-UP, ADJUSTMENT AND
CONNECTION ARE THE RESPONSIBILITY OF THE INSTALLER.
Make sure you have everything necessary for proper installation.
1. GROUNDED ELECTRICAL OUTLET is required. See Electric Requirements.
2. POWER CORD for electric dryers (except Canada).
3. GAS LINES (if a gas dryer) must meet National and Local Codes.
4. EXHAUST SYSTEM – must be rigid metal or flexible stiff walled metal exhaust ducting. See Exhaust Requirements.
7200 series
A. Height-overall
B. Width
C. Depth-With Dryer Door Open 90°
D. Depth
E. Bottom Vent Hole Location - From Back
To Center of Hole
Side Vent Hole - From Back To Center Of
Hole
INCH (CM)
38” (96.5)
27” (68.6)
46-7/16” (123.0)
28” (71.0)
7-1/2” (19)
8-1/2” (21.6)
NED7200TW-02033C 2007.9.6 10:22 AM Page 2