Filter
Top Products
8
Operating Sequence
Before using your tumble dryer for the first time, we
recommend you place a few damp cloths inside the
appliance and dry for 20 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Load The Laundry
Connect the appliance. Open the door (see picture).
Place the laundry in the drum, one item at a time,
shaking them out as much as possible. Close the
door. Please check the laundry does not get caught
between the door and filter.
2. Select The Required Time.
Turn the programme selector dial to the required
programme. The light Start/Pause starts to flash.
Turn the dial to the required time.
The lights Drying, and End come on.
At the end of the programme the selector dial must
be turned to position Off, to switch the machine off.
Attention!
If you turn the programme selector dial to another
programme when the machine is working, the lights
of the programme progress display start to flash. The
machine will not perform the new selected
programme.
3. Programme Option Buttons
Depending on the programme, different functions
can be combined. These must be selected after
choosing the desired programme and before
depressing the Start/Pause button. When these
buttons are pressed, the corresponding pilot lights
come on. When they are pressed again, the pilot
lights go out.
Delicate Button
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on. .
DELICATE is only suitable for use with loads of
up to 3kg!
When the programme has finished the pilot lights
End is on.
P1108
P1149
Textile Button
Press the Textile button repeatedly, to select the
desired option. The relevant light will light up.
You can select 2 different options:
Cotton: to be used for cotton, .
Synthetics to be used for synthetic or delicate
items.
When the programme has finished the pilot lights
End /Anticrease is on.
Start/Pause Button
Press this button to start the dryer after having
selected the programme and the options. The relevant
light will stop flashing. If the programme selector
dial is turned to another position, when the machine
is running, the buzzer will sound and the programme
phase indicator lights will flash. The drum turns
alternately in both directions during drying.
All drying programmes end with a 10 minute cooling
phase . You may remove the laundry after this phase.
If the door of the appliance or the small door at the
bottom is opened while the programme is running,
this button must be pressed again after closing the
door in order to restart the programme from the point
at which it was interrupted. This button must be
depressed also after a power failure and after having
reinserted the water reservoir, if it has been emptied
in the middle of a programme after lighting up of
light “Empty Tank”.
In both cases the light of the “Start/Pause” button
flashes to remind you that the start button needs to be
pressed again.
4. Indicator lights
These lights indicate the following functions:
• Drying light - this light indicates that the appliance
is in the drying phase
.
• End / Anticrease light - this light is on at the end of
the cooling phase, during the anti-creasing phase
and at the end of the programme.
• Empty Tank light - this light indicates that the
appliance is in the drying phase. This light comes
on at the end of the programme to remind you that
the water reservoir must be emptied out. If this
light illuminates during a programme this means
that the water reservoir is full. The buzzer sounds,
the programme stops, the light of the Start/Pause
button flashes. This light comes on also when the
water reservoir is not inserted correctly.
• Filter - this light illuminates at the end of the
programme to remind you that the filters must be
cleaned.
• Condenser- It comes on every 80 cycles to remind
you that the condenser must be cleaned.