Filter
Top Products
7
Operating Sequence
Before using your tumble dryer for the first time, we
recommend you place a few damp cloths inside the
appliance and dry for 20 minutes.
There may be dust inside a brand new tumble dryer.
Drying
1. Connect the appliance.
2. Open the door as per picture.
3. Load the items one at a time, shaking them out
loosely.
4. Close the door. Please check the laundry does not
get caught between the door and filter.
5. Select the drying time by turning the Time
Selector Dial clockwise.
6. If required, press the “low heat” Button.
7. Press the Start Button: the machine starts
operating. The “mains on” light comes on.
The drum turns alternately in both directions
during drying.
All drying programmes end with a 10 minute
cooling phase (position on selector dial).
The machine stops
automatically at the end of this phase (knob
pointer on position “O”). The mains-on light goes
out.
8. Immediately remove the laundry.
P1108
P1149
After each use
• Clean the filters (see page 9).
• Empty the water reservoir (see page 10).
Important!
If the drying programme has to be stopped before it
reaches the end, we recommend that you turn the
Time Selector Dial to position (cooling) and wait
until the end of this phase before removing the
laundry. This will avoid a build-up of heat inside the
appliance.
Modifying the programme
To change a programme which is running, turn the
Time Selector Dial clockwise to the required position.
125980573.qxp 2005-11-15 16:17 Page 7