Filter
Top Products
16
INSTALLATION
Attaching the water supply hose to the faucet
If you attach the water supply hose completely, it may cause a water leakage.
Faucet shape Wall-mounted faucets are best.
The distance is needed
1.6 cm or more
Attaching the hose union
1 Push the lock lever of the water
supply hose. Pulling the sleeve down,
lower the entire hose to disconnect
the hose union.
2 Check the diameter of the faucet.
When the faucet mouth is large,
loose the screws and remove the
inside ring to facilitate, attachment.
3 Loose 4 screws of the hose union,
push the hose union to the water
faucet.
4 Tighten the four screws evenly
around the faucet. In this time check
the gap is approx. 4 mm between the
nozzle and the ring.
5 Remove the seal from the union
and turn to the arrow destination
the nozzle to tighten securely.
6 Check the gap is approx. 1 to
3 mm between the nozzle and the
ring.
•
If the gap is wide, it may cause the water leak.
•
If it cause the water leakage during operation,
tighten the nozzle more securely.
Caution
•
If you attach the hose union again because of
moving house etc., loose the gap is approx. 4 mm
between the nozzle and the
ring. Then attach it according
above methods. They are
preventable the water leakage.
Connecting the water supply hose
1 Pull the sleeve down, then insert
the water supply hose.
2 Separate the sleeve until a click is
heard, then push it up.
3 Check to ensure that the lock
lever is hung on the nozzle. Next,
check to ensure that the water
supply hose does not come off by
pulling down on it.
4 Tighten the hose nut
on the end of the
water supply hose
securely to the water
intake valve.
Caution:
•
Check to ensure that the water
supply hose is properly installed by
turning the water on and checking for
leakage.
If there is leakage, connect it from the
first.
•
If you remove the water supply hose
after supplying water, water may
splash. Refer to the following
— "Removing the water supply hose".
Caution
•
The old inlet hose should not be reused.
•
If the faucets are not suited, please contact your
dealer.
•
Do not connect the hot water supplying
convenience.
•
In order to provide a permanent source of
water for your washing machine, it is suggested
that a branching water pipe (available separately)
be used.
Wall-mounted
shaped
Square
faucet
Movable
faucet
Multi-home
faucet
Hose union
Branching
water pipe
Joint
seal
Hose Union
Lock
lever
Water
supply
hose
Ring
Inside
ring
Approx.
4 mm.
Sleeve
Nozzle
Sleeve
Lock
lever
Hose nut
Water supply
hose
Water intake
valve
Ring
Nozzle
Approx.
4 mm
Approx.
1 to 3 mm