Filter
Top Products
LEARNING ABOUT YOUR
STEAMER
Please refer to the picture for each point
(1)
The control HANDLE on the end of the hose sits
just before the nozzle. The HANDLE is designed
to be heat free and is safe to grasp. Use the
HANDLE to aim the direction of the steam
released from the nozzle
(2)
The NOZZLE on the end of the handle is located
on the end of the steamer hose. Always hang the
NOZZLE end of the hose on the hanger rod when
not in use. Keep the NOZZLE point the NOZZLE
downward, water may condense and drip.
(3)
The ROD is designed to conveniently hang the
hose handle and also can support garments for
steaming
(4)
The
HOSE
extends from the base of the unit Do
not
pull
on the
HOSE
with undo tension as
damage to the hose may result
in
steam leakage
(5)
The ON/OFF switch is located on the front of the
base.
(6)
The WATER CONTAINER is filled through the
removable water valve on the bottom and should
be placed in the reservoir on the base. Avoid
spilling excess water into the reservoir as this
could cause the steamer to expel water from the
nozzle. Do not try to substitute another water
container for the one designed for this unit.
(7)
The WATER LEVEL can be seen visually in the
water container. Do not operate the steamer
without water in the WATER CONTAINER.
(8)
The steamer BASE houses the reservoir and
water container. It also supports the hanger rod
and hose.
(9)
The CASTERS allow the unit to roll freely
(10) The ELECTRICAL CORD plugs into a standard
three
-
prong plug. Use only three prong UL
approved extension cords with a minimum
20-
ampere rating
(11) The DRAIN
PLUG
is located on the side for
convenient drainage of the water reservoir.