Toastmaster 3314CAN Iron User Manual


 
wrinkles, firmly depress the burst of steam button. Between the individual
bursts of steam, pause for at least 5 seconds to let the iron reheat for
maximum additional steam. If water drops escape as you use the burst of
steam, turn the temperature control dial to a slightly warmer setting and
wait for the ready light to go out.
CAUTION: Avoid coming in contact with escaping steam.
USING THE SPRAY BUTTON
For a mist of water to moisten dry and difficult fabrics such as linen, cotton
or wool, or to handle stubborn wrinkles, press the spray button. The spray
function is also handy to moisten creases accidentally ironed in the fabric.
AUTOMATIC SAFETY SHUT-OFF
As a built-in safety measure, the iron is programmed to shut-off
automatically after 15 minutes. When the iron shuts off, the reset button
located on top of the iron handle will come on. If you wish to resume
ironing, simply push the reset button. The light will go out and the iron will
re-energize immediately. Diagram 4.
FILLING THE WATER TANK
1. Unplug the iron before filling.
2. Turn the variable steam dial to the lowest setting. Diagram 3.
3. Hold the iron upright but slightly tipped.
4. Using a measuring cup, slowly pour water into the water fill hole
opening. Diagram 5.
5. Check see-through water reservoir to see if iron is filled to maximum fill
line. Diagram 6.
Note: Your iron is designed to use tap water. However, if your water is very
hard, it is recommended you use distilled water. DO NOT use water from
home water softening systems because such water may contain minerals
that may harm the iron.
EMPTYING THE WATER TANK
The water tank should be emptied after each use. To do so:
1. When finished, turn temperature control dial to MIN, lowest setting,
and unplug the iron from the electrical outlet.
2. While the iron is still warm, hold the iron over a sink and allow the iron
to drain by tipping the point of the iron down.
3. Gently shake the iron to loosen any water drops that may be trapped.
The warmth of the iron should dry out any remaining water.
Note: If you empty the water tank after the iron has cooled, set the iron in an
upright position on its heel, plug it in and set the temperature dial to maximum
heat for 2 minutes. Then unplug the iron and let it cool before storing it.
6