Filter
Top Products
2. Place the Steam Control (
G
)
on
.
The production of steam automatically adjusts
to the temperature selected.
4
Prevents drips whilst ironing.
ANTI-DRIP FUNCTION
1. Place the thermostat control
(
H
) to match the type of fabric
to be ironed.
The light comes on (
I
). Wait for
the light to go off and come on
again before you start ironing
Our advice
Start with the fabrics to be ironed on a low temperature (•) and finish with those
which respond best to higher temperatures (••• or MAX)
If you iron a fabric made of a blend of fibres:set the temperature for the most
delicate fibre.
2
3
The electronic system cuts the power off and the auto-stop warning light
(
L
) flashes if the iron is left vertically on its heel for more than 8 minutes
or for more than 30 seconds if left horizontal.
To restart the iron, shake it gently until the warning light stops flashing.
NB.When the auto-stop safety switch operates, the thermostat light will
remain off.
AUTO-STOP SAFETY FEATURE
(depending on the model)
8
Place the Steam control (
G
) on DRY .You can start ironing when the
indicator light (
I
) comes on for the second time.
IRONING WITHOUT STEAM
SETTING THE TEMPERATURE
AND THE STEAM LEVEL
Linen
Cotton
Wool
Silk
(Viscose)
Synthetics
(Acetate, Acrylic,
Polyamide,
Polyester)
To improve ironing efficiency, this iron produces steam on the “synthetics”position,
thanks to a new sole plate design which allows you to iron delicate fabrics with
steam on a low setting.
Important
• Your iron will only produce steam when the thermostat
control is in the steam zone.When first switching on
the iron wait for 5 minutes after the iron is switched on for
steam to be produced.
• If you lower the thermostat, wait until the light goes out and comes on again before
ironing.
!
TO IRON LINEN OR COTTON
WITH A HIGH FLOW OF STEAM
7
1. Set the thermostat control to Linen or Cotton.
2. Press the “Jeans” (
K
)
(depending on the
model)
trigger while ironing. This increases the
flow of steam.
3. Do not press the trigger
(depending on the
model)
for more than 30 seconds.Wait a
minute before using it again.
Press repeatedly on the Spray button to
dampen the fabric.
or
Use the Burst of Steam button pressing two
or three times in quick succession to obtain a
more powerful burst of steam.
Important
Never use the Burst of Steam button on silk and
synthetics.
REMOVING THE STUBBORN CREASES
6
1. Hang the garment up and hold the fabric taut
2. Place the thermostat control (
H
) on MAX,
press repeatedly on the Burst of Steam
button and move the iron from top to
bottom.
Important
Hold the iron a few centimetres from the garment to
avoid burning delicate fabrics.
VERTICAL STEAM
!
5
!