Filter
Top Products
Your steam generator has been designed to operate using untreated tap water. However,if your water is
very hard, mix it 50% untreated tap water with 50% distilled water.
Do not add anything to the contents of the removable water tank,and do not use water from clothes
dryers, scented water, water from refrigerators,water from air conditioners or rain water. Also do not use
filtered,boiled or bottled mineral water.
These contain organic waste or mineral elements that become concentrated when heated and
cause spitting, brown staining or premature wear to your iron.
4- USING YOUR STEAM GENERATOR
1.Press the release button for the 2-part protective hood and fold it down over the tank to release the iron (6).
2.Completely unwind the power cord from its storage space before connecting to an earthed socket (7).
3. Press on the on / off switch (located on the side of the base unit) (a):the green light (located on the control panel)
flashes and the boiler heats up (b).It will take around 2 minutes for steam to be produced which is indicated when the
green “steam ready” light stops flashing (8)
.
• The first time the appliance is used,there may be some fumes and smell but this is not
harmful. They will not affect use and will disappear rapidly.
• When starting,and regularly while it is being used,your steam generator's electric pump injects water
into the boiler. It makes a noise but this is quite normal.You may also hear a clicking noise which is the
steam valve opening.Again this is normal.If you are pressing on the steam control button at this time
you may lose a little steam pressure momentarily.
3- PREPARING YOUR STEAM GENERATOR
1.To carry your steam generator:
- place the iron on the iron rest of the generator and raise the hood over the iron until it locks into place (audible click) (1).
- grasp the handle of the protective hood to carry your steam generator (2).
2. Place your steam generator on a stable, horizontal heat-resistant surface.
3. Grasp the handles of the removable tank and pull horizontally to remove it (3).
4. Fill up the water tank taking care not to exceed the maximum level just below the filler cover (4).
5. Replace it firmly in its housing, making sure it is fully into place (5).
The water to use in your steam generator :
Types of water to be avoided :
CLICK
1 2 3 4 5
6 7
(a)
(b)
8