Groupe SEB USA - T-FAL PRO EXPRESS TURBO Iron User Manual


 
8- VERTICAL STEAM IRONING
1. Set the iron temperature control slide and the steam output control dial (located on the
control panel) to the MAX position.
2. Hang the garment on a coat hanger and hold the fabric slightly taut with one hand.
As steam is very hot, never attempt to remove creases from a garment while it is
being worn, always hang garment on a coat hanger.
3. Holding the iron in a vertical position, tilted slightly forwards, press repeatedly on the steam
control button (under the iron handle) moving the iron from top to bottom (13).
Recommendations : for fabrics other than linen or cotton, hold the iron
a few centimetres from the garment to avoid burning the fabric.
7-
WHEN THE RED LIGHT “WATER TANK EMPTY” COMES ON
There is no more steam.The removable water tank is empty.
1. Grasp the handles of the removable tank and pull horizontally to remove it; fill with water.
2. Replace and push it firmly into place.
3. Press the “restart” button on the control panel to continue ironing (12).
To prime the steam circuit, either before using the iron for the first time, or if you have not
used the steam function for a few minutes, press the steam control button several times in a row,
holding the iron away from your clothes. This will enable any cold water to be ejected from the
steam circuit.
Type of fabric
Linen
Cotton
● ● ●
Wool
Silk, Viscose
● ●
Synthetic,
Polyester,Acetate,
Acrylic, Polyamide
Setting the temperature
control slide
Setting the steam output
control dial
• Iron temperature control slide setting:
- Start with the fabrics to be ironed at a low temperature (•) and finish with those which need higher
temperatures (••• or Max).
- Mixed fibre fabric: set the ironing temperature to the setting for the most delicate fabric.
- Woollen garments:press repeatedly on the steam control button to obtain short bursts of steam,
without placing the iron on the garment itself.
• Steam output control dial setting:
- Thick fabric: increase the steam setting.
- At a low temperature : set the steam output control dial to the low position.
S
ETTING THE TEMPERATURE CONTROL SLIDE AND STEAM OUTPUT CONTROL DIAL ACCORDING TO TYPE OF FABRIC TO BE IRONED
:
linen
cotton
lin
coton
laine
soie
synth.
wool
silk
synthetic
linen
cotton
lin
coton
laine
soie
synth.
wool
silk
synthetic
linen
cotton
lin
coton
laine
soie
synth.
wool
silk
synthetic
13
12
NOT GTA2 035613 10/01/07 14:20 Page 5