2- LOCKING SYSTEM FOR RETAINING THE IRON
ON THE BASE
CLICK
1 2 3 4 5
Your iron has been designed to operate using untreated tap water.
• Heat concentrates the elements contained in water during evaporation.The types of water listed below
contain organic waste or mineral elements that can cause spitting, brown staining or premature wear of the
appliance: water from clothes dryers, scented or softened water, water from refrigerators, batteries or air
conditioners, pure distilledor demineralised water or rain water should not be used in your iron.Also do not
use boiled, filtered or bottled water.
If your water is very hard mix 50% untreated tap water and 50% distilled or
demineralised water.
3- PREPARING YOUR STEAM GENERATOR
1.To carry your steam generator by the iron handle :
- place the iron on the iron rest of the generator and raise the retaining hoop over the iron until it locks into place
(audible click) (1).
- grasp the handle of the iron to carry your steam generator (2).
2. Place your steam generator on a stable, horizontal heat-resistant surface.
3. Grasp the handles of the removable tank and pull horizontally to remove it (3).
4. Fill up the water tank taking care not to exceed the maximum level just below the filler cover (4).
5. Replace it firmly in its housing, making sure it is fully into place (5).
The water to use in your steam generator :
CLIC
Your steam generator is equipped
with a retaining clip which locks
the iron on its casing for
easier transport and storage
UnlockLock
NOT GTA2 035613 10/01/07 14:20 Page 3