When the
Auto-Stop
warning light is
on, it is normal for
the thermostat
light to remain
off.
8. Auto-Stop safety feature (depending on model)
- For your safety, the electronic system cuts off the power and the auto-
stop indicator light flashes
- fig. 13
when :
• The iron remains motionless for more than 8 minutes on its heel.
• The iron remains flat or on its side for more than 30 seconds.
- To restart the iron, just move it gently until the warning light stops flashing.
9. Autoclean Catalys
®
Soleplate
-
Your iron is equipped with a self-cleaning soleplate - fig. 14 which works
by catalysis.
- Its exclusive coating helps continuously eliminate all the impurities
generated by normal use. It is recommended that you always stand your
iron on his heel to preserve its self-cleaning coating.
Dry Ironing
- Choose your ironing program.
- Set the steam control to DRY
- fig. 1.
- You may start ironing when the thermostat light goes out.
Caring for your iron
BE CAREFUL ! Unplug your iron and let it cool down before cleaning it.
Cleaning the anti-calc valve (once per month)
- Unplug your iron and empty the water tank.
- To remove the antiscale valve, set your thermostat on the position MAX
- fig. 10,
place the steam control on STEAM , and the valve can now be removed from your
iron
- fig. 15.
Never touch the end of the valve
- Soak the valve in a cup of white vinegar or plain lemon juice for 4 hours - fig. 16.
- Rinse the valve under running water.
- Replace the anti-calc valve.
The iron will not function
without the anti-calc valve
1. Self-cleaning
In order to extend the life of your iron, use the Self-Cleaning
function once a month.
- Set the iron to DRY .
- Fill the water tank to maximum.
- Set the iron on his heel, with the water tank full, and set the thermostat
to MAX
- fig. 10.
- When the thermostat light goes out, unplug the iron and hold it in a
horizontal position, over a sink.
- Remove the anti-calc valve.
Recommendations:
the self-cleaning
function helps to
slow down the
scaling up of your
iron.
6
UltimateAutoclean_GB.qxd:TEFAL193 27/05/08 9:07 Page 6