Groupe SEB USA - T-FAL FV5110 Iron User Manual


 
4- STORING YOUR IRON
FOR YOUR SAFETY
Warning ! The voltage of your electrical installation must correspond to that of the
iron (220V-240V). Connecting to the wrong voltage may cause irreversible damage
to the iron and will invalidate the guarantee.
This iron must always be plugged into an earthed socket.
If using a mains extension lead, ensure that it is correctly rated (10A), with an
earth.
If the electrical cord becomes damaged, it must be immediately replaced by an
Approved Service Centre to avoid any danger.
Never immerse your iron in water !
The appliance must be unplugged before filling or emptying the water tank.
If the appliance falls, have it checked by a professional before using it again; unseen
damage may be dangerous.
The soleplate may be very hot :
- Never touch it.
- Always let it cool off before putting it away.
- Never leave your iron unattended when it is plugged in or while the soleplate is
still hot.
- Always keep your iron out of the reach of children.
NEVER DISMANTLE YOUR IRON ;
ALWAYS CONTACT AN APPROVED SERVICE CENTRE.
This product has been designed for domestic use only.Any professional use,
inappropriate use or failure to comply with the instructions, the manufacturer
accepts no responsibility and the guarantee will not apply.
- Unplug the iron and wait for the soleplate to cool down.
- Empty the water tank and set the steam control to DRY. A little water
may remain in the tank.
- Wind the cord around the heel at the back of the iron.
- Store the iron on its heel.