Filter
Top Products
4
Store your iron
• Set the steam control to and unplug the iron.
• Wait until the soleplate cools down and empty the reservoir.
A little water may remain in the reservoir.
• Wind the cord around the heel of the iron.
• Store the cold iron on its heel (
fig 11).
Obtain more steam (according to model)
• Press the Superpressing button now and again to remove
stubborn creases (fig 7).
Wait a few seconds
between each shot before
pressing the button again.
Vertical steam ironing (according to model)
Ideal for removing creases in suits, jackets, skirts, curtains, etc. :
• Hang the garment on a hanger and hold the fabric slightly taut
with one hand.
• Set the thermostat control to MAX (fig 9).
• Press the Superpressing button repeatedly (fig 7) moving
the iron from top to bottom (fig 10).
• Hold the iron a few centimetres from the fabric to avoid burning
delicate fabrics.
Every fifth time you press
the button, return the iron
to the horizontal position.
The steam is very hot, so
you should always do this
with the garment on a
hanger – never while
someone is wearing it.
Spray Function
• Whether steam or dry ironing, you are able to use the Spray
button (fig 8) to dampen laundry to remove stubborn creases.
Cleaning the anti-calc valve (once a month)
Maintenance and cleaning
• Unplug your iron and empty the water tank.
• Press the self-clean ejection button (fig 12a) and remove the
anti-calc cartridge (fig 12b)
• Soak the valve in a cup of white spirit vinegar or plain lemon
juice for 4 hours.
• Rinse the valve under running water and Replace the anti-calc
valve.
Unplug your iron and let
it cool down before clean-
ing it.
The iron will not function
without the anti-calc
valve. Never touch the
end of the valve !
Carry out the self-cleaning operation (once a month)
• Unplug your iron, set the steam control to and fill the
water reservoir to MAX.
• Place your iron on its heel, set the thermostat button to MAX,
plug in your iron and wait for the indicator light to go out.
• Unplug the iron and place it horizontally over a sink.
• Press the self-clean ejection button (
fig 12a) and remove the
anticalc cartridge (fig 12b).
• Gently shake the iron over the sink until some of the water
(along with impurities) runs out through the soleplate.
• At the end of the operation, put the anticalc cartridge back in
place and then plug in your iron for 2 minutes on its heel to dry
the soleplate.
To slow down scaling and
prolong the useful life of
your iron, carry out the
self-cleaning operation
once a month.
Supergliss_8 Langues_018063 19/12/06 9:37 Page 4