Filter
Top Products
Before first use
Remove any adhesive stickers, plastic covers
or cardboard sleeves from the soleplate.
Remove any remaining adhesive by rubbing
the soleplate with a cloth dampened with
methylated spirits.
Filling the boiler with water when cold
Before filing the boiler with water, ensure
that the power is turned off and the plug is
removed from the power outlet.
Unscrew the boiler cap. Using the funnel
provided, fill the boiler with 1 litre of water.
Replace the boiler cap and tighten.
Note: The non-corrosive stainless steel boiler
has been designed to allow you to use tap
water in your professional ironing system.
However, in very hard water areas, Sunbeam
recommends the use of distilled or
demineralised water. For best performance,
we recommend the use of Sunbeam Water
Demineraliser, available from Sunbeam
Service Centres and selected retailers. This
produces up to 30 litres of demineralised
water.
Caution: Do not fill the boiler with fabric
conditioners, starches, scented water, or any
other solution, as these will damage the
steam mechanism. Do not use contaminated
water.
Using your professional ironing system
1.Insert the plug into a 230/240V power
outlet and turn the power on.
2.Depress the iron and boiler on/off button to
turn the appliance on.
Note: when turned on for the first time your
new iron may give off vapours for up to 10
minutes. This is due to the initial heating
of the materials used. It is safe, not
detrimental to the performance of the iron
and will not reoccur.
3.Turn the temperature dial on the iron to
the desired setting. The thermostat light
will illuminate to indicate that the iron is
heating. It will go out once the iron has
reached the selected temperature.
Note: when changing the temperature dial
from a higher setting to a lower setting,
allow the iron to cool for at least 2 minutes
before continuing ironing.
4.The green steam ready indicator will turn
on and off several times during the first
minute. Once it comes on and stays
illuminated, you can commence ironing.
Before using steam on a garment, direct a
shot of steam into the air to release any
remaining condensation.
4
Using your professional ironing
system