Filter
Top Products
MAINTENANCE
Other than the recommended instructions in this pamphlet, no further maintenance is necessary.
However, following is a list of frequently asked questions and their resolutions. If for any reason
your iron continues to exhibit one of these symptoms, or requires repair for another reason,
send it to the Sunbeam Appliance Service Center or call our Consumer Hot Line l-800-597-5978.
SYMPTOM
RESOLUTION
Iron emits an odor
l
Iron gives off an odor when turned on for the first time
l
Allow ten minutes for odor to disappear.
Iron does not heat
l
Iron should be plugged into a 120 volt, AC electrical outlet only.
l
The temperature dial must be set at the desired temperature.
l
The auto shut-off feature may have been activated (Some Models
On/y).
Move the iron back and forth to restart.
Iron does not steam
l
The water tank may be empty. Turn steam valve to DRY
and add water.
l
Allow iron to heat, then set the steam dial to one of the steam settings.
Use temperature settings within the steam band.
l
There may be an obstruction. Remove steam valve by turning it
to CLEAN. Replace and set the steam dial to one of the steam settings.
SHOT OF STEAM” feature
l
The water tank must be at least
l/4
full.
does not work
l
Temperature must be set to steam position.
l
Iron should be in the horizontal position.
l
Prime pump briefly.
l
Allow a short pause between shots.
l
Be sure to
fully
deoress the
S
HOT
OF
S
TEAM
button.
SPRAY
MI@'
featI.Jre
does not work
Iron is leaking
l
The water tank must be at least
l/4
full.
l
The variable steam dial must be set on DRY until the iron is hot.
l
The temperature setting is too low to produce steam
(See lroning
Guide)
Cord will not pull out
l
Pull cord firmly to unwind.
l
Press winding button to reset device, then pull cord.
Cord does not retract
l
Pull out the cord once and wind cord evenly on the reel.