Filter
Top Products
999
STORING YOUR IRON
1. Allow the iron to cool.
2. If you do not use your iron on a daily basis, empty the water reservoir
after each use for a longer iron life. To do so, turn the iron upside
down to allow water to flow from the fill hole. Shake the iron gently
to remove trapped water drops.
3.
Loosely loop the power cord together and store the iron on its heel rest.
Important: Wrapping the cord around the iron too tightly can damage
the cord.
Tip: When not ironing, always set the Steam dial to DRY and the Fabric
Select dial to OFF.
Maintaining Your Iron
CLEANING THE SOLEPLATE
Clean the soleplate if starch or other residue accumulate.
To clean the Soleplate:
1. Allow the iron to cool and then wipe it with a soft, damp cloth.
WARNING: DO NOT use abrasive cleansers, scouring pads or
vinegar to clean the soleplate, this will damage the finish.
2. Run the iron over an all-cotton cloth to remove any residue.
888
Steam Ironing
1. Follow the instructions for “Filling the Water Reservoir” on Page 6.
2. Plug the cord into a 120-Volt AC outlet.
3. Turn the Fabric Select dial to the Steam ironing fabric setting
you desire (Linen, Cotton or Wool) and allow the iron to heat
for 2 minutes. While the iron is heating, make sure it is sitting
on its heel rest on a stable, protected surface.
Tip: Refer to the Ironing Guide on Page 10 for the recommended setting
for your fabric.
4. After the iron has heated (2 minutes), turn the Steam dial to the
appropriate steam setting.
5. The Temperature Indicator Light remains on until the iron reaches
the appropriate temperature.
How To Use the Special Functions
SPRAY MIST
®
The SPRAY MIST
®
feature dampens the fabric to aid in removing wrinkles
from heavy fabrics and for setting creases.
To use the SPRAY MIST
®
feature:
Press the SPRAY MIST
®
button firmly.
Caring for Your Iron After Use
TURNING OFF YOUR IRON
1. Turn the Steam dial to DRY and the Fabric Select dial to OFF.
2. Unplug the iron from the power source.
WARNING: NEVER yank the power cord when unplugging the iron,
this can damage the cord.