Filter
Top Products
INSTALLING YOUR WASHER
-
DRYER
IMPORTANT
In the accessories bag you will also find a spanner that
is to be used for removing brackets and leveling
washer
-
dryer
feet.
REMOVING SHIPPING BRACKETS
1.
Remove back panel screws and lift panel clear
(Fig. 1).
2.
Remove fixing screws from the four
brackets and
cross bearing (Fig. 2) then remove brackets.
3.
Fix back panel with 3 screws previously removed
(Fig. 3).
4.
Close the
4 holes on the cabinet with the plastic
blanking plugs that you will find in the accessories
bag (Fig. 3).
L
EVELING
After selecting a permanent location, the machine
should be properly leveled to prevent vibration.
To do this, adjust one or b
oth front levelers, as needed,
after loosening the lock nuts. Once your washer is pe
r-
fectly leveled, be sure to tighten the lock nuts (Fig. 4).
Page 2
FOR YOUR OWN PROTECTION, AND TO PREVENT ACCIDENTS, INJURY AND FIRE, PLEASE READ
THE FOLLOWING CAREFULLY:
•
Destroy the carton and plastic bags after the washer
-
dryer has been unpacked.
•
Children should never be left alone or unattended
in the
area where appliances are located.
•
Washer installation and grounding must be done in
accordance with local codes by a qualified installer.
Installation instructions are included in this manual for
the installer's
reference.
•
Use only low sudsing detergents suitable for front
loa
d
ing washers, or a small amount of regular dete
r-
gent. The soap suds should never exceed the mid
-
line
of the port
-
hole.
•
The washer must be plugged into a properly grounded
three (3) prong electrical outlet. For your safety, the
third or round grounding prong must never be removed.
DO NOT USE AN EXT
ENSION CORD.
•
Repair or replacement of a part should be made only by
a qualified service technician to prevent personal injury
or damage to the machine. Ask your dealer for a list of
authorized re
pair service companies.
•
Disconnect power to the washer at the circuit breaker or
fuse box, or unplug the machine in an emergency, or
when servicing is required. Have the installer show you
and label the prope
r switch or fuse at the electrical
disconnect box.
WARNING
-
The Appliance Should Be Connected To
An Individual Branch Circui
t With No. 14 AWG Wire
And Protected By 15 A Fuse or Breaker.